drill motor short [Archive]

Stephanie

02-15-2003, 12:23 AM

ah, another broken motor scenario

most of the other teams seem to have experienced a problem with the plastic brush holder breaking; the same thing happened to us (the little black clip holding it in snapped off). now, we are having a problem with the motor shorting. we cannot figure out what is causing it. can anyone please offer suggestions?

thanks so much, in advance

sanddrag

02-15-2003, 05:22 AM

Are you shure it's shorting or is it just arcing? Maybe the brushes are not fully pushed against the commutator.

Stephanie

02-16-2003, 01:39 AM

it seems to be working now... we used some electrical tape to hold the brush in place, and reinforced the other motor

thanks :)

sanddrag

02-16-2003, 02:45 AM

Originally posted by Stephanie
it seems to be working now... we used some electrical tape to hold the brush in place, and reinforced the other motor

thanks :)

Uhhhhh, I don't think brushes are made to be held in place with any kind of tape. That's just asking for problems. Try epoxying the brush hoods and the motor endbell -- just wherever it broke.