PDA

View Full Version : Window motors


team222badbrad
01-22-2002, 05:18 PM
Has anyone found out where to but gears for these that slip over the one on the motor that drive the plastic belting from the previous years?? I have the gear from last year all measure up, but we dont have any easy way of machining one!:( I know these motors a different from last year. I dont think there is any use for these motors unless you make a gear for them!! Last year we used them as our ball pivot.

Any help or suggestions would be helpful thanks!!!

Bad Brad

team222badbrad
01-22-2002, 05:23 PM
my finger musta slipped lol *******but should be buy*****


and measure should be measured up!

Justin Stiltner
01-22-2002, 07:42 PM
what we did was to make a cup attached to a shaft that was notched to fit the plastic belt driving gear that was on the motors gear...
it works and was really strong, tho it takes some time to make.. but it shouldent be taht bad.