PDA

View Full Version : Servo Motors

Manoel
02-10-2002, 08:01 PM
Anyone have the torque ratings for the servos provided in the kit?
Joe Ross
02-10-2002, 08:14 PM
42 inch-oz, although it has been said in the past that servo manufactures inflate their specs by 2x.

Edit: this is the stall torque, and it is also from memory.
Manoel
02-10-2002, 08:39 PM
Is this the stall torque?
Jon Lawton
02-11-2002, 04:43 AM
What the heck are you doing with servos that you have to worry about their stall torque?
Manoel
02-11-2002, 10:28 AM
Isn't it obvious? :)
Trying to replace a heavy motor with two servos, to perform a light-load task... :D
Mike o.
02-11-2002, 04:52 PM
if u are talking about the Hitec HS-300 servos, the torque is 42 inches per oz at 4.8v and 49 inches per oz at 6v. u can also goto the Hitec site which is www.hitecrcd.com . if u think that it is of any use.

Mike O'Brien
Team 384