Getting off CMT pulleys

[Adam Y.]

Gosh darn it. I installed a CMT pulley and I did not know that it would be permamently stuck on the globe motor. Does anyone have any ideas of getting them off of the shaft?

[Rickertsen2]

Gosh darn it. I installed a CMT pulley and I did not know that it would be permamently stuck on the globe motor. Does anyone have any ideas of getting them off of the shaft?
What's a CMT pulley?

[Adam Y.]

They are just a pulley with a special hub that was in one of the robot kits.

[Gary Bonner]

If I recall correctly, putting the set screw in the other hole releases the hub if you didn't over torque the screw in the first place.

[Jack21]

If I recall correctly, putting the set screw in the other hole releases the hub if you didn't over torque the screw in the first place.
you could try a small gear puller (common at most flea markets)