PDA

View Full Version : Full Field

bradford86
01-25-2005, 04:49 PM
Check out our full field at http://www.pennrobotics.org/files
Vashts6583
01-25-2005, 05:04 PM
any way to open these files?
bradford86
01-25-2005, 05:26 PM
To open the files, you have to download the wrar340.exe-winRar file from the pennrobotics.org/files. The same place where you can get the full field.
UsmanB
01-25-2005, 05:43 PM
i think he was asking how to open the actual files after their unzipped. autocad right?
bradford86
01-25-2005, 06:15 PM
The files made in Autodeck Inventor 8. Should work hopfully.
crazykid234
02-10-2005, 07:15 PM
what happened to the website? I can't even get into the homepage.
Daniel Brim
03-02-2005, 01:12 AM
Thanks a lot. There were two constraints that didn't work, but I just supressed them and grounded everything. Don't forget to change the HP triangle to 48 inches too :) . Anyways, in my AIA submission I want to include a special thanks to whoever modeled that. Who should I credit?
Design006
03-12-2005, 10:25 AM
You should credit T.J Ciszczon from Penn Robotics Team 135. He is a Penn High senior and has taken a single class of inventor. Thank you for requesting that information. I hope our team hasn't responded to late to allow you time to represent him. Good luck with your awards.

Grant