aeasson
02-02-2008, 03:34 PM
Our team is using EasyC.
On page 33, the WPLIB manual states that for all controllers it is necessary to set the direction for any ports used for digital I/O – identifying each as either used for input or output.
However, I cannot find the SetDirection in the EasyC environment.
If it is not a built in function, then what are the possible values for direction in the function call.
Thank you
On page 33, the WPLIB manual states that for all controllers it is necessary to set the direction for any ports used for digital I/O – identifying each as either used for input or output.
However, I cannot find the SetDirection in the EasyC environment.
If it is not a built in function, then what are the possible values for direction in the function call.
Thank you