|
|
|
 I personally think any student should be allowed to participate, as long as he/she is helpful and active. FIRST, to me, is about inspiration, not elitism. - Aignam [more] |
 |
|
||||||||||||||
|
|||||||||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I personally think any student should be allowed to participate, as long as he/she is helpful and active. FIRST, to me, is about inspiration, not elitism. - Aignam [more] |
|
|
||||||||||||||
|
|||||||||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Defective clutch on motor/servo?
I found out that one of the clutches on motors and servos may be defective. If I pull the clutch out of the servo, the square hole inside the servo is at its center. If I put the clutch back on the servo, the clutch's square hole is about 30 degrees off center. Is the clutch defective? Can I fix it?
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Drill Motor Clutch | GrahamS314 | Motors | 2 | 02-22-2004 12:05 AM |
| Bosch Drill Motor Clutch Spring Dimensions?? | aaronbr28040 | Motors | 3 | 02-18-2004 06:52 PM |
| Driving a clutch | Kevin A | Chit-Chat | 18 | 07-03-2003 03:02 PM |
| Drill gearbox clutch | Joe P | Technical Discussion | 3 | 03-12-2003 12:22 PM |
| Locking the clutch | Joe P | Motors | 12 | 03-01-2003 08:17 PM |
Threaded Mode