|
|
|
 The next hint will be game hint #3. Everyone will go crazy trying to figure out which of the fake hints was hint #2. - Joe Ross [more] |
 |
|
||||||||||||||
|
|||||||||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| The next hint will be game hint #3. Everyone will go crazy trying to figure out which of the fake hints was hint #2. - Joe Ross [more] |
|
|
||||||||||||||
|
|||||||||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
FRC: Reset and Program Controls
My team is having some troubles with the electrical layouts and we want to make things much easier for the programmers. We were thinking of creating a switch for the reset and program buttons on the FRC controller. There is a three pin port where is says Reset/Prog. I was wondering if we could create a switch for the reset and program buttons instead of having to press them directly on the board. If that is possible than how would I wire the push buttons switches to the pins? Does anybody have a schematic? Thanks
 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Code runs only once, fails on reset | roknjohn | Programming | 7 | 02-21-2005 07:24 PM |
| Program error after controller reset | randomperson | Programming | 6 | 01-04-2005 10:31 PM |
| FRC Program State Frozen at Power-up | WillyC | IFI Control System | 4 | 02-14-2004 05:05 PM |
| Anyone looking for more program space? | archiver | 2001 | 13 | 06-24-2002 01:20 AM |
Threaded Mode