|
|
|
 Mentor: How is that held in place?
CAD Lead: Go to the hardware store and buy a bag of constraints and put the constraints on the robot. - Kenyow [more] |
 |
|
||||||||||||||
|
|||||||||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Mentor: How is that held in place?
CAD Lead: Go to the hardware store and buy a bag of constraints and put the constraints on the robot. - Kenyow [more] |
|
|
||||||||||||||
|
|||||||||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Updateing Jaguar with serial
Hello,
I'm trying to update the jaguars, sometimes the program connects and sometimes it does not. We have it connected as shown in the manual. Also the buttons "Run" and "Stop" as shown in the manual are not available in our program. Is there a setting im missing or wiring. Thanks -Sean 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Power Driver Station with Serial | pyr0b0y | Technical Discussion | 6 | 04-30-2009 06:53 PM |
| System Freeze with serial output | ay2b | WindRiver C++ | 2 | 01-27-2009 09:30 PM |
| Can I control a victor/jaguar with an RC receiver | Bruceb | Electrical | 3 | 12-30-2008 09:50 AM |
| Using USB with Serial Tower | Mick | Lego Mindstorm Discussion | 11 | 11-07-2006 08:54 AM |
| Problem with communicating with STAMP through serial port | Skabana159 | Technical Discussion | 2 | 02-06-2003 08:10 PM |
Threaded Mode