|
|
|
 The game is as much a competition of strategies as it is of robots. There is never any one "best strategy."
If teams choose to use this as their strategy, find one that will beat them. - srjjs [more] |
 |
|
||||||||||||||
|
|||||||||||||||
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| The game is as much a competition of strategies as it is of robots. There is never any one "best strategy."
If teams choose to use this as their strategy, find one that will beat them. - srjjs [more] |
|
|
||||||||||||||
|
|||||||||||||||
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Pneumatics electrical wiring and programming
Posted by Dan Grostick at 1/18/2001 10:08 AM EST
Engineer on team #267, Demolition Squad, from North Broward Prep / St. Andrews. I've posted information (in the White Papers section) on the electrical wiring and programming of the pneumatics subsystem. I want to share my experiences programming the pneumatics demo board shown at the First kickoff. Dan Grostick (267) |
|
#2
06-23-2002, 10:10 PM
|
|||
|
|||
|
Comment out the relay line in default program
Posted by Vince Wilczynski at 1/20/2001 8:15 PM EST
Engineer on team #124, Whalers, from New London / Montville/ Williams School and Notheast Utilities / US Coast Guard Academy. In Reply to: Pneumatics electrical wiring and programming Posted by Dan Grostick on 1/18/2001 10:08 AM EST: Thanks Dan. One note, make sure you comment out the relay5 lines in the default program as noted below: 'relay5_fwd = p1_sw_aux1 'Port 1 Aux1 = Relay 5 Forward 'relay5_rev = p1_sw_aux2 'Port 1 Aux2 = Relay 5 Forward / |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Error found in programming for the pump and pressure switch | sjharobotics | Programming | 4 | 02-06-2002 04:46 PM |
Linear Mode
