Drills: The ball bearings are gone?

CD has a vast store of knowledge, information, and wisdom. Add to it. - JaneYoung [more]

		Chief Delphi > Technical > Motors
Drills: The ball bearings are gone?

Unsung FIRST Heroes

The Chief Delphi Forums are sponsored by Innovation First International, Inc.

Sponsor Info.

View First Unread

Thread Tools

Rate Thread

Display Modes

01-21-2003, 10:57 PM

BobbyG

Registered User

#0433 (Firebirds)

Join Date: Jan 2003

Location: Philadelphia

Posts: 1

BobbyG is an unknown quantity at this point

Drills: The ball bearings are gone?

Year after year, I would open the top of the drill drive and all the ball bearings would fall out. In went the 6mm set screws and I would be done.
Is there anything special on this years drills to keep the clutch from slipping Joe?

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
2004 Game	BBFIRSTCHICK	General Forum	112	04-19-2003 04:12 PM
Curie Division Robots information... (not complete)	archiver	2001	3	06-24-2002 02:13 AM
A little tip about those drill transmissions and bearings	archiver	2001	6	06-23-2002 11:22 PM
30" ball sits up there real pretty	archiver	2001	18	06-23-2002 09:49 PM
ksc - ball bots ohm my	katie86	Regional Competitions	8	03-10-2002 09:52 PM

All times are GMT -5. The time now is 09:48 PM.

The Chief Delphi Forums are sponsored by Innovation First, Inc.