|
|
|
 I like what FIRST said about it best: They consider it part of the "Game Challenge" - Alavinus [more] |
 |
|
||||||||||||||
|
|||||||||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| I like what FIRST said about it best: They consider it part of the "Game Challenge" - Alavinus [more] |
|
|
||||||||||||||
|
|||||||||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#2
02-28-2004, 10:19 PM
|
|||
|
|||
|
Re: Spare parts?
Check in the manual under section 5 - Robot. Look particularly at section 5.2.5 R09. FIRST issued a further clarification on the Q & A section of their website.
ID: 883 Section: 5.2.5 Status: Answered Date Answered: 2/26/2004 Q: Must all fabrication cease after the ship date (2/26/04)? I assume this is the intent, but this is not explicitly stated as it has been in previous years. A: The intent is that you stop all work ("tools down") as of the ship date until you get to the event. Rule R9 addresses what you may do at the event. There is not much wiggle room here. When the robots ship, put your tools down. If you didn't make spare parts before you shipped, you CAN'T make them after. 
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rules on making spare parts fyi | DougHogg | General Forum | 0 | 04-02-2003 03:18 PM |
| who needs spare parts | archiver | 2000 | 0 | 06-23-2002 10:55 PM |
| Calling all Lawyers... ...Define "all parts" | Joe Johnson | General Forum | 10 | 03-13-2002 02:12 PM |
| Spare Parts Table | Jeremy Davis | Technical Discussion | 2 | 03-09-2002 10:40 PM |
Linear Mode
