|
|
|
 I think that everyone should just take a step back and look at the whole picture, FIRST is a family, not an organization full of regions, we all try to help each other, not 'cause it benefits us, but because it's graciously proffesional. - Mike Schroeder [more] |
 |
|
||||||||||||||
|
|||||||||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
Drill Gearbox Gear Size?
From what I've read, the drill pinion is a 0.7 module (which means it's metric?). Does anyone have any information on the gears (suns, planets, rings) inside the gearbox? Is it a safe assumption that they are 0.7 module also?
|
|
#2
05-30-2002, 08:26 PM
|
|||||
|
|||||
|
It looks like the first 2 stages are 0.7 mod, I get the mating gears for it from PIC-Design.com. We only used the motor pinion on our gearbox last year.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| drill motor gear noise | arshacker | Motors | 2 | 02-04-2003 06:52 PM |
| drill gearbox schematic? | Jeff Sharpe | Technical Discussion | 3 | 01-20-2003 11:18 PM |
| Info on gear on drill motor | archiver | 2000 | 2 | 06-23-2002 09:58 PM |
| "Motors and Drive train edition" of Fresh From the Forum | Ken Leung | Bulletins and Newsletters | 6 | 01-29-2002 11:32 AM |
| Drivetrain help | thedillybar | Technical Discussion | 9 | 01-08-2002 08:54 PM |
Linear Mode
