|
|
|
 Just the fact we were selected to compete in the eliminations energized the kids more than anything I had seen - Taylor [more] |
 |
|
||||||||||||||
|
|||||||||||||||
 |
| Thread Tools |
Rating: 
|
Display Modes |
|
|
|
| Just the fact we were selected to compete in the eliminations energized the kids more than anything I had seen - Taylor [more] |
|
|
||||||||||||||
|
|||||||||||||||
|
| Thread Tools |
Rating:
|
Display Modes |
|
#2
02-16-2008, 11:09 AM
|
|||
|
|||
|
Re: Where to connect IR bored?
The board can be powered by either the main 12v power, or you could wire it off of the backup battery.. From what I can gather, most people are running this thing off of a 20A breaker on their main breaker panel. You can see what folks said when I asked the same question at http://www.chiefdelphi.com/forums/sh...ad.php?t=63475
--Tracy 
|
|
#3
02-18-2008, 09:29 AM
|
||||
|
||||
|
Re: Where to connect IR bored?
you can also use the digital in/out pins for power... does anyone know which pins in the pwm you would use for ground and power with this method? is it just red and black (expectable)
i really dont wanna risk reversing the polarity because aparently whoever designed the IR board knows nothing about diodes Last edited by Trav-O : 02-18-2008 at 10:14 AM. Reason: Clerification
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Where to connect the backup battery charger | Never_Fade | Electrical | 6 | 01-16-2008 10:54 PM |
| connect laptop to tv | mormannoob | Chit-Chat | 6 | 03-01-2007 11:21 PM |
| where do we connect our motors for navigate.c | thelastride | Programming | 5 | 02-15-2004 02:45 PM |
| im bored | BBFIRSTCHICK | Chit-Chat | 12 | 12-10-2003 08:18 PM |
| I am BORED! | MikeFromTeam71 | Chit-Chat | 26 | 08-26-2002 05:47 AM |
Linear Mode
