|
|
|
 Along with having good manners, having good judgement goes a long way in life. - ebarker [more] |
 |
|
||||||||||||||
|
|||||||||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Along with having good manners, having good judgement goes a long way in life. - ebarker [more] |
|
|
||||||||||||||
|
|||||||||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
GTS confusion
our program compiles without error but when we try and use Get_Encoder_1_Count(), we get a programming state error. Anyone having similar problems or had similar problems and knows what im doing wrong?
|
|
#2
02-17-2008, 04:33 PM
|
||||
|
||||
|
Re: GTS confusion
Make sure you have followed the instructions in Kevin Watson's readme, assuming you are using that code. Usually the interrupts are not enabled in one of the headers. (Or does that just result in a returned 0 value...?) Either way, make sure the readme steps are followed.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| old GTS | seanl | Electrical | 0 | 02-09-2008 03:30 PM |
| GTS Code | windell747 | Programming | 5 | 02-06-2008 11:29 PM |
| GTS strange behavior | iwdu15 | Programming | 6 | 02-01-2007 05:46 PM |
| GTS Counting | gnirts | Programming | 13 | 04-21-2006 08:15 PM |
| GTS code Problems | caderader | Programming | 8 | 02-13-2006 06:23 PM |
Linear Mode
