|
|
|
 Don't try to kiss your stapler remover, those prongs are sharp... - MissInformation [more] |
 |
|
||||||||||||||
|
|||||||||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Don't try to kiss your stapler remover, those prongs are sharp... - MissInformation [more] |
|
|
||||||||||||||
|
|||||||||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
House Dimensions
Does anybody know the angle of the incline on the House? This is vital to the construction of our robot. thanks, Team 27 appreciates your help.
|
|
#2
10-03-2001, 07:00 AM
|
|||
|
|||
|
All the angles of the 2 x 4 the field strcutures are 45 degrees
|
|
#3
10-03-2001, 03:28 PM
|
|||
|
|||
|
House Dimensions2
I was wondering if the 20'' X 20'' square on the incline of the house is centered on that incline. Also, I calculated that the length of the 2X4 that makes up the incline is about 50.5 inches, did anybody else get something different. Again, Team 27 greatly appreciates your help.
|
|
#4
10-04-2001, 08:58 AM
|
|||
|
|||
|
The scoring holes on the house are 20 x 18.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| scoring ramp dimensions | archiver | 2000 | 3 | 06-23-2002 11:13 PM |
| Where did you get your robot's dimensions? | Jan Olligs | Inventor | 6 | 04-09-2002 09:17 PM |
| Robot dimensions & weight restrictions revealed? | Mike Soukup | Rules/Strategy | 4 | 10-24-2001 07:51 PM |
| Shelf and board dimensions still don't add up | kmcclary | Chief Delphi Invitational | 12 | 10-20-2001 08:12 AM |
| Field and shelf missing dimensions | kmcclary | Chief Delphi Invitational | 3 | 10-12-2001 05:21 PM |
Linear Mode
