|
|
|
 The question was asked. The GDC gave their ruling. If you don't like it then maybe you can run your own tournament and let people ignore your rulings. - Daniel_LaFleur [more] |
 |
|
||||||||||||||
|
|||||||||||||||
 |
| Thread Tools |
Rating: 
|
Display Modes |
|
|
|
| The question was asked. The GDC gave their ruling. If you don't like it then maybe you can run your own tournament and let people ignore your rulings. - Daniel_LaFleur [more] |
|
|
||||||||||||||
|
|||||||||||||||
|
| Thread Tools |
Rating:
|
Display Modes |
|
#1
|
|||
|
|||
|
Scorbot ER 3
Hello everybody,
What's the main components need to Scorbot ER 3 to make it compatable with new computer ?? 
|
|
#2
07-28-2011, 06:43 AM
|
||||
|
||||
|
Re: Scorbot ER 3
We have a Scorbot ER 5 at college, and some ER-VII. One of which I installed. From what I remember they used a com port (RS232)
Here is a website for the Scorbot line: http://www.theoldrobots.com/scorbot.html And also manuals!!! http://www.theoldrobots.com/scorbot3.html
|
|
#3
07-28-2011, 07:11 AM
|
|||
|
|||
|
Re: Scorbot ER 3
I wanna ask you Mr.Munter ...
we don't need a card to change the connection ,because the there is changing in the pins : PC Computer SCORBOT-ER III Controller (D25 female connector) (D25 male connector Pin 2 to Pin 3 Pin 3 to Pin 2 Pin 7 to Pin 7 Pin 4 to Pin 5 Pin 6 to Pin 8 and 20
|
|
#4
07-28-2011, 07:31 AM
|
||||
|
||||
|
Re: Scorbot ER 3
So the controller has a 25 pin connector and the computer has a 9 pin connector, right?
You just need the cable pinout to make a cable?
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
