Log in

View Full Version : Serial-to-CAN adapter

SpikeyBot293
20-01-2012, 17:19
Our serial-to-CAN adapter in the KOP was not assembled, as in the RJ11 connector wires were not plugged into the DB-9 connector. There appears to be no literature anywhere how to correctly assemble this adapter. Has anyone encountered this issue and found the assembly instructions?
dyanoshak
20-01-2012, 17:26
Our serial-to-CAN adapter in the KOP was not assembled, as in the RJ11 connector wires were not plugged into the DB-9 connector. There appears to be no literature anywhere how to correctly assemble this adapter. Has anyone encountered this issue and found the assembly instructions?

Go to www.ti.com/jaguar (http://www.ti.com/jaguar) and look for Getting Started (MDL-BDC24) (http://www.ti.com/lit/ug/spmu131b/spmu131b.pdf).

Look in the section titled "RS232 Cable" on page 26 for the adapter assembly instructions.

-David