Log in

View Full Version : Default code

Hebrew
25-01-2012, 16:33
Do I have to edit the default code to get a motor hookup to work? I have deployed an unchanged code, all lights are green, and the motor is not running with joystick 1.

I get an axis camer not found in the driver station log as my only error and it is running through a jaguar. PWM 1 and 2 are hooked up with the three prong slot
Mike AA
25-01-2012, 19:53
Do I have to edit the default code to get a motor hookup to work? I have deployed an unchanged code, all lights are green, and the motor is not running with joystick 1.

I get an axis camer not found in the driver station log as my only error and it is running through a jaguar. PWM 1 and 2 are hooked up with the three prong slot

Is the light on the Jag solid or flashing orange? Did you image the Crio? Did you enable the robot on the driver station?