Powering a Conveyor Roller

[msimon785]

Hi, CD
Team 1515 ran into a dilemma when finding out that the 3/8" keyed shaft from McMaster is backordered, basically until stop-build day. Our design as is involves 2.5" ABS (tubular) fixed to AM Hubs run on a live axle.

Both the 3/8" AM Hubs and the 3/8" McMaster shaft are currently out of stock.

We would like to ask the CD community what other teams suggest in terms of powering the rollers. Our two constraints are: 3/8" shaft DIA and quick. Ideally, we would like to use a live axle setup.

[JB987]

How about MSC or Grainger? Both have presence in LA area and you should be able to get what you need quickly.

[AdamHeard]

Hi, CD
Team 1515 ran into a dilemma when finding out that the 3/8" keyed shaft from McMaster is backordered, basically until stop-build day. Our design as is involves 2.5" ABS (tubular) fixed to AM Hubs run on a live axle.

Both the 3/8" AM Hubs and the 3/8" McMaster shaft are currently out of stock.

We would like to ask the CD community what other teams suggest in terms of powering the rollers. Our two constraints are: 3/8" shaft DIA and quick. Ideally, we would like to use a live axle setup.

Joe got you set up with shaft, if you need hubs order anything from AM with a smaller bore, and we'll gladly bore out and broach them for you.

[msimon785]

Thanks so much!
MSC has everything we need to go about this. We will order the 10mm AM hubs instead of the 3/8" its a difference of .001", which is more than marginal.
To Adam, if we need any lathe-work, I'll make sure to contact you. Thank you for your support.

[AdamHeard]

Thanks so much!
MSC has everything we need to go about this. We will order the 10mm AM hubs instead of the 3/8" its a difference of .001", which is more than marginal.
To Adam, if we need any lathe-work, I'll make sure to contact you. Thank you for your support.

10mm is more like .394

[msimon785]

Hm. AndyMark is wrong. @AndyBaker, you should probably fix that.
Bore: 10mm (0.374 inch), with a 4mm (0.157 inch) keyway

[pfreivald]

Find local machine shops, or really anyone with a mill (were we closer, we'd do it for you... and if you want to pay shipping, we still will!) Keying a shaft is trivial with the right equipment, and 3/8" steel bar stock is ubiquitous.

[Mk.32]

Find local machine shops, or really anyone with a mill (were we closer, we'd do it for you... and if you want to pay shipping, we still will!) Keying a shaft is trivial with the right equipment, and 3/8" steel bar stock is ubiquitous.

We just did this a few times with only basic machining equipment. I am sure you can find someone that can do it for you.

We are powering our rollers with polycod, stick a pully on the drive shaft of the motor and lathe a grove into roller.

[msimon785]

After searching through McMaster, the 10mm roller bearings have identical mounts to the .375". We're just going to switch out the bearings.
Thanks, everyone