Microswitch program..

[Luiz12]

Basically I want to press a button and let go but the motor begins to run until the switch is activated then I want it to roll back for 5 seconds. Can someone give me an example on how to do this using Labview.

[Keyreaper]

Is this what you are trying to accomplish? I think some other programmers on here could help out and also make sure I haven't made mistakes....
http://imgur.com/a/oSPD4

[Luiz12]

Yes thank you..

[Keyreaper]

Yes thank you..

I'm not sure it actually works, as I don't normally work with the wait.vi function so I'd build it up just to make sure.

[MAldridge]

make sure you don't put that in teleop. That wait will stall out the loop.

[Keyreaper]

make sure you don't put that in teleop. That wait will stall out the loop.

He is correct... Perhaps a Elapsed timer would work better.

[MAldridge]

actually, you would do good to do it the way you have it here, but throw it into a separate loop in periodic tasks. There is no good way that I have found yet to do a delay on the cRIO without running it in parallel. Mainly because the timestamp is kind of flakey.