View Full Version : Programming Cypress Board
I can't figure out how to program the Cypress board. Computer says it's connected, go into the programmer and can't do anything with it. Says it fails to connect. How do I fix it?
Alright I have it programmed but none of the computers with the driver station will recognize it on the DS and the classmate won't even let me program it, it's not recognized. Please Help
Alan Anderson
19-02-2012, 21:37
What did you use to "program" it? You should be following the "How to Configure Your I/O Module" instructions starting on page 39 of the Getting Started (http://www.usfirst.org/sites/default/files/GettingStartedwiththe2012FRCControlSystem_RevA.pdf ) document.
I did and when I connect it to the classmate with the driver station open it constantly makes the sound of disconnecting.
vBulletin® v3.6.4, Copyright ©2000-2017, Jelsoft Enterprises Ltd.