marccenter
20-02-2012, 19:47
CD,
Been busy building the robot with sophomore team so finally go around to firing up the new cRIO2 and do not have robot communication.
I've setup the cRIO for the past 2 years so I am familiar with the FRC drills:
1) Labview install from USB drive, 2) Labview updates; 3) Classmate imaging;
4) setting proper IP addresses, 5) Imaging cRIO ; 6) Downloading baseline code using team IP address.
I've done all that have all green lights flashing but cannot communicate with cRIO via F1 enable or mouse enable. What have I forgotten?
Been busy building the robot with sophomore team so finally go around to firing up the new cRIO2 and do not have robot communication.
I've setup the cRIO for the past 2 years so I am familiar with the FRC drills:
1) Labview install from USB drive, 2) Labview updates; 3) Classmate imaging;
4) setting proper IP addresses, 5) Imaging cRIO ; 6) Downloading baseline code using team IP address.
I've done all that have all green lights flashing but cannot communicate with cRIO via F1 enable or mouse enable. What have I forgotten?