Team 1716- 2012 - Osprey

[McGurky]

Team 1716 would like to introduce their 2012 Rebound Rumble Robot -- Osprey!

http://www.frc1716.org/2012robot.png

Video can be found here (http://www.youtube.com/watch?v=iLqO6oN_kjo&feature=plcp&context=C36788e9UDOEgsToPDskIwOrMm6EKrS8tzFvtklp1w ):


-Wide drive base allows for ease of ball collection and balancing on bridge
-6 wheel, Center dropped, 4 CIM drive train
-2 stage automatic convener system
-270 Degree Turreted shooter
-Single Flywheel shooter, Consistently scoring 3 pointers in offensive zone
-Passive wedge to lower bridge, gather balls and balance
-16 Different autonomous modes, utilizing alliance cooperation, for maximum scoring
-Able to cross bridge and barrier with ease

To Wisconsin Regional and beyond!

-Good luck to all teams

Team 1716 Redbird Robotics

[Grim Tuesday]

Really nice video, really nice robot. I haven't seen many wide robots with 6 WD, the wheels are so close they're almost touching!

[ThirteenOfTwo]

Heads up: your bumpers as shown here are ILLEGAL as per rule <R35>.

<R35>: Teams shall display their team number on the Bumpers in four locations at approximately 90° intervals around the perimeter of the Robot. The numerals must be at least 4 in. high, at least ¾ in. in stroke width, and be either white in color or outlined in white. Team numbers must be clearly visible from a distance of not less than 100 ft, so that judges, referees, and announcers can easily identify competing Robots.

Question on 2/8/12 by Team 1619:
Q. Does R35 limit the team number quantity to exactly four locations? For instance, if one side of the robot has two short bumpers separated by a gap, can the complete team number be put on both of those bumpers? Thus, there'd be two complete team numbers on one side of the robot.
A. Rule [R35] requires that the team number be displayed in four locations, no more or fewer.
Your bumpers appear to display your team number in five locations.

[McGurky]

Thank you, our team was aware of the illegal bumper configuration, and made the necessary modifications prior to bagging the robot.