RS-232 issue

[farmersvilleRob]

We're using a sensor on our robot that uses the COM port on the cRIO to communicate information. We're having an issue getting any data from the sensor, though. We've used a COM port on a PC with the same cable we're using on the robot successfully. We've also adapted our Labview code to operate successfully on the PC with the sensor.

Does anyone have any ideas? Does the cRIO perhaps have swapped Tx and Rx pins compared to the standard PC pinout? (Not sure if it's considered a DTE or DCE). I did some googling and I'm under the impression that the pinout should be the same as a PC. Thanks in advance

[Jay1986]

woah, what sensor is this because sensors are usually only DIO or Analog.

[RufflesRidge]

Make sure to disable the Console Out switch in the cRIo Imaging Tool.

[Kevin Sevcik]

Make sure to disable the Console Out switch in the cRIo Imaging Tool.Or physically disabled if you have a 8-slot FRC cRIO.

[farmersvilleRob]

Make sure to disable the Console Out switch in the cRIo Imaging Tool.

We will try this tomorrow. We figured something as much! trickster cRIO