Bumper rules question

[JZB]

http://up363.siz.co.il/up2/ntemjgm2yg3z.png (http://www.siz.co.il/)

We are building our bumpers and we dont understand the rule fully,
we painted figure A and B,
We are asking if both ways are right?
Is only one right?
Thx.

[IndySam]

A


R22

ROBOTS are required to use BUMPERS to protect all outside corners of the FRAME PERIMETER. For adequate protection, at least 8 in. of BUMPER must be placed on each side of each outside corner (see Figure 4-2).

The dimension defined in R22 is measured along the FRAME PERIMETER. The portion of the BUMPER that extends into the corner is not included in the 8 in. requirement.

[ehochstein]

http://frc-manual.usfirst.org/upload/images/2013/1/4-2a.JPG

[protoserge]

http://up363.siz.co.il/up2/ntemjgm2yg3z.png (http://www.siz.co.il/)

We are building our bumpers and we dont understand the rule fully,
we painted figure A and B,
We are asking if both ways are right?
Is only one right?
Thx.

A is correct as per the rules. B is not.