Labview Activation

[katsauga]

How do I activate my version of LabView? I have only gotten it into evaluation mode:eek:

[F22Rapture]

The activation key is on the screenstepslive document for installing LabView

[katsauga]

what?? I dont know what that is

[Mark McLeod]

Go to Start -> All Programs and look under National Instruments for the NI License Manager to activate your products.

The license code you should be using is S14X86763

[katsauga]

thank you so much! its working now

[Joe Ross]

what?? I dont know what that is

Most of the control system documentation has moved to a website called screenstepslive. https://wpilib.screenstepslive.com/s/3120

In particular, you need Installing LabVIEW for FRC 2013 (https://wpilib.screenstepslive.com/s/3120/m/8559/l/92193-installing-labview-for-frc-2013)

[apalrd]

The license code you should be using is S14X86763

Where did you find this code?

The packet I have lists S/N M77X14459 as the serial number on the back, which doesn't work in the activation wizard (although it sends me an email saying it worked, with an activation code which doesn't work).

The SN you listed is correct, it just worked for me.

[Greg McKaskle]

Due to a manufacturing mistake, the DVDs sleeves were given unique serial numbers rather than a common one. The licensing was setup for a single serial number, not a long list.

The correct SX serial number was printed on a card that was in the packet, but it is in a rather small font. These were built overseas and by the time it was discovered there was not time to correct it.

It has been a bit support issue, as you can imagine.
Greg McKaskle

[Mark McLeod]

Here's what the card Greg mentioned with the correct FRC activation code, included in everyone's LabVIEW envelope, looks like.
See the tiny print in the lower left hand corner.

[Alan Anderson]

The correct number is also in the detailed step-by-step instructions (http://wpilib.screenstepslive.com/s/3120/m/8559/l/92193-installing-labview-for-frc-2013) for installing LabVIEW.