Volts Problem [Archive]

View Full Version : Volts Problem

Avihu

31-01-2013, 15:05

hello
when we run the program on our robot the volts Values stays on 0.00 .. what could be the problem?

MrForbes

31-01-2013, 15:07

You probably either did not connect the wires from the power distribution board to the analog bumper, or you did not add the jumper on the analog bumper.

Avihu

31-01-2013, 15:34

umm.. where does the jumer goes? I mean on the analog there are several pins..
wich should i use/cover..?

MrForbes

31-01-2013, 15:37

R71 in the Game Manual.

http://frc-manual.usfirst.org/upload/images/2013/1/Figure4-10.jpg

Jon Stratis

31-01-2013, 15:38

In the picture on the first page here (http://www.usfirst.org/sites/default/files/uploadedFiles/Robotics_Programs/FRC/Game_and_Season__Info/2012_Assets/Analog%20Breakout.pdf) you'll see the entire analog breakout. In the top left corner of the image there are 3 exposed pins, spaced so they would fit a normal PWM wire. Place a 2-pin jumper over the two pins on the left of the picture - in other words, the two pins closest to the side edge of the board.