cRIO 8-Slot Error 56 Fix

[geomapguy]

Hello all,

Our team was having issues imaging our 8-Slot cRIO with the 2013 Imaging Tool. We kept getting Error 56.

We discovered a fix:
1. Get a computer without the 2013 imaging tool
2. Install the 2012 imaging tool with Image V43.
3. Copy the 2013_v47 from the LabView Program Files on the computer with the 2013 imaging tool. (Program Files/National Instruments/Labview 2012/project/cRIO Tool/FRC Images)
4. Place the new image file on the new computer (Program Files/National Instruments/LabView 2011/project/cRIO Tool/FRC Image)
5. Run the 2012 Imaging Tool and select the v47 image.
6. It should load quicker and actually work.

[Doug Norman]

Your solution may have less to do with using the 2012 imaging tool and more to do with using a different computer. On the computer that doesn't work, you might check the advanced network setting properties to make sure you don't have extra IP addresses configured.

[geomapguy]

Your solution may have less to do with using the 2012 imaging tool and more to do with using a different computer. On the computer that doesn't work, you might check the advanced network setting properties to make sure you don't have extra IP addresses configured.

We tried using a couple of computers running Windows 7 and the 2013 Imaging Tool and we had no success.

One of the Applications Engineers suggested we try the 2012 tool and it worked.

Our team suspects that the 8-Slot is a little slower which caused some of the issues due to the phasing out of it.