Trouble deploying Program to cRIO with NetBeans

[quando04]

I finished programming and ready to deploy my program for a week now. However I cannot get pass where it says "Welcome To LabView Real-Time" and "FPGD software guild .....". Then Netbeans just continue to run without an end, and robot doesn't move.

On another note, how do I get the D-Link to work as an Access Point?

[BradAMiller]

Here's an article that describes the download process and what you should see for each step. This might help figure out what's going on in your case.

http://Wpilib.screenstepslive.com/s/3120/m/7885/l/97458

Brad