How much force to push the ramp?

[archiver]

Posted by colleen -- T190 at 1/11/2001 7:51 PM EST


Engineer on team #190, Gompei, from Massachusetts Academy of Math and Science and WPI.



So many have already built fields or had the opportunity to play with one at kickoff--

About how much force do you think need to be applied to push the ramp down? (i.e. if you need to reset the ramp such that you can drive over, and it's "up" on your side"

How bout lifting it? That would be equal to the downward force at that point-- but does anyone have weight specs.. or estimates.. to get a rough idea?

thanks
colleen

[archiver]

Posted by Ed at 1/11/2001 8:28 PM EST


Coach on team #34, DaimlerChrysler/ Bob Jones High , from Bob Jones High / New Century High and DaimlerChrysler/Bob Jones High/ New Century High.


In Reply to: How much force to push the ramp?
Posted by colleen -- T190 on 1/11/2001 7:51 PM EST:



I attended the kickoff and found the amount of force required to "switch" the position of the unloaded bridge to be relitively minor compared to the possibility of the force required if another robot is on the far end, especially if I'm not applying the force at the very end of the bridge. It could be 130 lbs or more ! Yikes !