Log in

View Full Version : pic: RAMP Inspired Gearbox

Sh1ine
25-12-2013, 17:43
[cdm-description=photo]39241[/cdm-description]
Andrew Lawrence
25-12-2013, 17:45
Looks great! This familiar design (http://www.wcproducts.net/wcp-single-3cim/) is a good way of running 3 CIM single speeds.

Just curious - why is the bearing on the bottom sticking out? Are you only running 3/16" thick plates?
Sh1ine
25-12-2013, 20:53
No we use the bearing to locate the gearbox properly on the chassis.
Andrew Lawrence
25-12-2013, 21:00
No we use the bearing to locate the gearbox properly on the chassis.

Smart. I like that.
Cory
25-12-2013, 21:06
It's hard to tell but your fillet sizes look a little small if you would be milling your plates. If you water jet, carry on.