Banebot Wheels 1/2 inch keyed shaft

[Gearheads1]

I've tried to figure it out on the Banebots site and can't. Do Banebots 1/2 shaft keyed wheels require shaft collars to keep them in place with their keys, or are there set screws on the wheels? Thanks for your help!

[Dan.Tyler]

Need to add retention. No set screws.

[MetalJacket]

I'm not 100% certain however my team did use banebots wheels last year (we bought them un-broached though, it was cheaper to do it ourselves) and they did not have setscrews. I would assume that the broached ones would be the same.

[Gearheads1]

Thanks!

[Dan.Tyler]

To clarify:
Half inch keyed round and half inch hex versions of the wheels both come without set screws and without a place to put set screws.

You can retain them with shaft collars, c clips, e clips, bolts/washers, cotter pins, expanding axle, bolts/washers into the axle, etc. Or just use a tapered, oversized key.

I don't think that modifying them for set screws is a good solution. Getting some of the banebots hubs might give you additional options.

[Gearheads1]

Thanks, we ordered shaft collars to keep them in place.