Problems with startup build

[katsauga]

I have attempted several times to run the FRC Boot-Up Deployment in Labview, and each time, it says successful. But when I go to the driver station, the robot code is not deployed upon startup and I must manually deploy it via robot main. does anyone know why this is?

[Whippet]

Could you post a screen recording of your workflow deploying the code?

[katsauga]

so you would like to record me running the Boot Up deployment?

[xXhunter47Xx]

I think I had that same problem.
Do you just deploy it from RobotMain.vi? Because that's just debug mode, the cRIO won't retain the code.
You have to build the code and then run it as startup.
Go to build specifications on your main project page.
Click it, then right click FRC Bootup Development or something along those lines
Click build (doesn't have to be connected to build)
Once it's built, connect to the robot, right click it again and this time don't click build click run as startup.
Once it's deployed it will prompt you to reboot the cRIO. Power cycle the robot.
It should work now.

[Whippet]

Yes, you may be forgetting a step or two causing the problems. The recording would make it easier to identify the problem.

[EDIT]: Or try it exactly as xXhunter47Xx said to. If it doesn't work like that, it may be a problem with your cRIO image.