Read CAN current output? [Archive]

View Full Version : Read CAN current output?

alarmrobotics

11-01-2015, 14:08

I read in the manual that the new power distribution board has an interface to read the current output. I was wondering how I can read this in Labview?

Sincerely,
ALARM ROBOTICS 2079

Cecil

11-01-2015, 14:22

Check at the very bottom of this page. (http://wpilib.screenstepslive.com/s/4485/m/13811/l/292165-labview-porting-guide-2014-to-2015) There are brand new .VI's to handle all of the PDP's current sensing.