Wago's and such

[Keaton Hunter]

http://i.imgur.com/LstAUoV.jpg?1This may be a stupid question but i cant seem to find a place where i can buy these specifically, i did however look at the wago website and there are a lot of different screw drivers. I think that one of those is a updated version of this one but i dont know which one is pretty much the same, if someone could please help that would be awesome because we really need like 2 more of these. Thanks.(btw this is my first time posting on chief Delphi so go easy on me)

[Jon Stratis]

You don't need an actual WAGO tool... Just take it to your local hardware store and get a couple of screw drivers that are about the same size.

[Foster]

The blade width is the important part. Buy one that is slightly longer and bend it to have an offset in it.



----------
\
\
----------(=======)


Nice for getting into tight places.

An angled one is also good.


\
\
\
----------------(=======)


Real picture here:

http://www.newark.com/wago/210-658/operating-tool-3-5-x-0-5-mm-short/dp/79K2417

Since they are cheap at your local cheap tool place it won't hurt to make a few of them....

..... mostly since they seem to sprout little feet and walk off.

[Keaton Hunter]

i got the problem solved.

[cglrcng]

http://www.newark.com/wago/777-310/universal-topjob-tool-2-5-mm-to/dp/29K5114?MER=BN-EN-PDP-29K5114

http://www.newark.com/wago/210-722/terminal-block-operating-tool/dp/51R0264

Plenty more at that 2nd. link.

[Keaton Hunter]

The blade width is the important part. Buy one that is slightly longer and bend it to have an offset in it.



----------
\
\
----------(=======)


Nice for getting into tight places.

An angled one is also good.


\
\
\
----------------(=======)


Real picture here:

http://www.newark.com/wago/210-658/operating-tool-3-5-x-0-5-mm-short/dp/79K2417

Since they are cheap at your local cheap tool place it won't hurt to make a few of them....

..... mostly since they seem to sprout little feet and walk off.i solved the prohttp://imgur.com/PjjXompblem