Bridge Reimageing Utility

[Phildirt]

This is our first time trying to communicate with our robot since our last competition, and I can't even see our radio. We are a rookie team and we had never experienced this before the competition. My wireless is turned on.

Any and all help is appreciated

Randal 5502

[KosmicKhaos]

Reset and reconfigure it just as you did when you first got it.
If you don't know how you configured it when you first got it follow this (http://wpilib.screenstepslive.com/s/4485/m/13503/l/144986-programming-your-radio-for-home-use) guide. Also the router should be in Access Point 2.4GHz mode (AP 2.4GHz) not Bridge mode. You can put it back in AP mode by moving the little switch on the back.

[SenorZ]

Just make sure you go to that (x86) folder. I idiotically wasted quite a lot of time trying to reinstall the labview software because I was looking in the regular Program Files folder.

Getting old.

[Ben Wolsieffer]

The reason it is necessary to reset and reconfigure the radio is that it gets new settings uploaded by the radio kiosk at the competition. This allows it to connect to the field, but it no longer works at home until it is reconfigured.

[Phildirt]

Thanks for replying, but when i searched for the file, it wasn't there. So should i reinstall labview? or should i just reinstall the update suite?
Thanks, Randal/5502

[Phildirt]

Thanks to anyone who replied!! I found the file and succsesfully got our radio reconfigured!! Again, thanks.
Thanks, Randal/5502