DigitalInput gyro class help

[zDrakon]

So I'm trying to create a DigitalInput gyro class, and have tried googling for any available open source libraries, seems not.

I believe I'm supposed to make my own Gyro class to extend the empty "Gyro" class. My team's gyro only uses digital input, so... how exactly could I start off using the DigitalInput class to get values from the gyro and basically do what AnalogGyro does (calibrate, getAngle, reset, free, etc.) since it comes with those empty methods.

[Joe Ross]

What is the part number of the gyro you are trying to use?

[zDrakon]

I've been confused on this. Just talked to others and seems like we know what we're going to do now. The part was https://www.sparkfun.com/products/10121.

Anyways if I need more help I'll post again here.

[fovea1959]

how are you handling hooking the 3.3 device up t a 5V roboRIO I2C? Are you using level shifters, or is it just working?

[GeeTwo]

how are you handling hooking the 3.3 device up t a 5V roboRIO I2C? Are you using level shifters, or is it just working?

From the RoboRIO RIO User's Manual (http://www.ni.com/pdf/manuals/374474a.pdf), page 10, lower right cell of the table in the I2Csection:
I2C lines with 3.3 V output, 3.3 V/5 V-compatible input. Refer to the I2C Lines section for more information.

[fovea1959]

From the RoboRIO RIO User's Manual (http://www.ni.com/pdf/manuals/374474a.pdf), page 10, lower right cell of the table in the I2Csection:

d'oh! thanks.