Log in

View Full Version : does anybody

Greg Perkins
30-08-2002, 09:27
does anybody know the distance from screw to screw on the drill transmission(clutch screws) i am making motormounts for my battlebot. info for this question would be greatly appreciated asap:)

Badjokeguy
sanddrag
30-08-2002, 13:20
I would just look at the 2002 Competition manual and see if it's there or just take some calipers and measure it yourself. No calipers, a ruler with small increments will do just as well.
Gary Dillard
30-08-2002, 16:42
I haven't found the specific dimension you're asking for. Here's a pretty detailed link on dis-assembling the transmission, including reference to some whitepapers:

http://www.lions.odu.edu/~averma/powerpoint/drill/
mtaman02
30-08-2002, 19:43
[QUOTE]sanddrag

I would just look at the 2002 Competition manual and see if it's there or just take some calipers and measure it yourself. No calipers, a ruler with small increments will do just as well.



I agree with sanddrag.
Greg Perkins
31-08-2002, 14:38
ithe unfortunate problem is i dont have a caliper! and the motor shaft goes right where the ruler should go!!! i guess i will have to go to the manual!:(

Badjokeguy
sanddrag
31-08-2002, 19:04
Or you could just take it apart and take that piece off because the manual is mighty large.
Greg Perkins
31-08-2002, 19:30
i just took the transmission apart, and wow!! i hadnt taken one apart before. i figured out how to mount it but i still do not know the distance between the screws. like i said before does anybody know the distance, please HELP!!!

Badjokeguy
sanddrag
31-08-2002, 19:35
That front black clutch piece with the screw holes comes off and you should be able to measure it with a ruler. I would just go measure it for you but the parts are locked up at school.
R Bohannan
28-09-2002, 22:34
Hey Badjokeguy.
I have a set of calipers in my desk as does your robot ops coordinator. Ask and you shall receive!