Dual stick controlling with a 360 controller

[Crazykid0011]

Ok so first year programmer here and im looking for a way to make use of both sticks on the 360 controller. More specifically using one stick to control one set of motors and the other to control the other set. im not new to programming but i am new to LabView. excuse me if there is already another thread about this topic im not very good at searching forums.

thanks in advance guys
-Crazykid

[Mark McLeod]

Just route the wires out of the joystick to the different motors.

[Crazykid0011]

Thanks took me a few minutes to figure out I had referenced the drive system instead of motors so the config you gave me wasn't working. But It works now so thanks.