Can't Deploy Code

[Dave_4539]

Our team has been recently working on an off-season robot and have run into the problem that we can't deploy code. We are using a brand new roboRIO that has been re-imaged to the newest version. We program using Labview, the code builds fine but when I go to "Run as Startup" there will be a conflict message saying "Connection failed. The network address might be invalid or the target is not responding." I am tethering to the roboRIO via USB. When the robot is turned on and USB connected, the COMM light on the roboRIO turns red.
If anyone has had a similar experience or knows how to fix this problem your feedback would be greatly appreciated. Thanks!

[mshafer1]

Is it in safe mode? (status light blinks in patterns of two)
What team number did you use for the roboRIO configuration?
Can you post a screen shot of the project explorer (and is it configured for the same team number?)?
When you connected the roboRIO, did the NI ethernet over usb driver install?

I am a 6yr veteran that now works at NI. If you would like to email me or let me call you directly, send me a private message and I'll give you my contact info.

[adciv]

There's a few things that could be here. Check what IP/Network name the project expects the roborio to be at. If you're trying to load by USB, ensure it is set to 172.22.11.2 . Check your firewalls and disable. Also ensure you aren't connected to the RIO over FTP or SFTP (ports 21 & 22).

[Taggerun]

Our team has been recently working on an off-season robot and have run into the problem that we can't deploy code. We are using a brand new roboRIO that has been re-imaged to the newest version. We program using Labview, the code builds fine but when I go to "Run as Startup" there will be a conflict message saying "Connection failed. The network address might be invalid or the target is not responding." I am tethering to the roboRIO via USB. When the robot is turned on and USB connected, the COMM light on the roboRIO turns red.
If anyone has had a similar experience or knows how to fix this problem your feedback would be greatly appreciated. Thanks!

If you are using Windows 10, I would find a different computer. We had the same issue with our 2016 robot on Windows 10 (with all correct settings). When we used a Windows 7 computer everything went correctly.
Thanks,
Taggerun

[kingca]

Also make sure you're not connected to any other connection at the time.