Jon K.
09-01-2005, 20:18
Thread created automatically to discuss a document in the White Papers.
Tetra Connector In MasterCAM (http://www.chiefdelphi.com/forums/papers.php?&action=single&paperid=409) by Jon K.
If anyone needs this file, it is for the Tetra Connectors in MasterCAM version 9.1 My team was planning on using it, then we were able to get them done by an engineer with laser cutting capabilities, but here is the file.
Tetra Connector In MasterCAM (http://www.chiefdelphi.com/forums/papers.php?&action=single&paperid=409) by Jon K.
If anyone needs this file, it is for the Tetra Connectors in MasterCAM version 9.1 My team was planning on using it, then we were able to get them done by an engineer with laser cutting capabilities, but here is the file.