what do u think we used this 4 :D

[arbershametaj]

http://img219.exs.cx/img219/4466/p10100307im.jpg get back at me

[UsmanB]

do u mind croping the image a bit, its so big; its about 200% my screen size.

[roboticsguy1988]

:ahh: :ahh: :ahh: WHOAH that is big, and my screen is set at 1280 X 1024.

[Ianworld]

part of your tetra grabber :) Actually in general any really odd parts this year are going to be used for grabbing tetras because thats the only option other than drivetrain. I suppose there could be a couple other nifty ideas, but thats basicalyl all there is.

[NoodleKnight]

Looks like it's for a three prong claw mechanism

[Stephen P]

The bottom one looks a little like a bearing holder, but probably isn't. Anyhow it looks neat.

[Andrew Hospodor]

I think it is too small for a tetra holder (look at the size of the carpet and compare to the piece). It is probably part of a gear box assembly that has had a lot of material removed to conserve weight. (that's my guess)

[NoodleKnight]

They're just the claw joints, the larger piece is where the prongs are attatched. The smaller piece is attatched to a linear moving shaft which will allow the claws to open and close.

[pyroslev]

Looks like parts to a motor and bearing assembly. Maybe part of a sub-system for a lift or arm?