Putting assemblies into other assemblies

[Crewmmbr21]

When I put an assembly(inserted) into another assembly(main), the motion constraints that I have on the inserted assembly will not move in the main assembly unless I edit the inserted assembly. Is there any way that I can somehow take these motion constraints and make them move in the main assembly? If anyone could help, it would be greatly appreciated. Thanks! :D I already checked the tutorials and didn't find any helpful information.

[petek]

Have you tried making the subassembly constraints adaptive and driving them in the main assembly?

[Squirrelrock]

The other thing that you could do is reassemble the sub assy's in the large assy and drive from there, but that's more work than ^^^.

Squirrel

[Ein]

Tutorial on adaptivity both in parts and assemblies

Part 1 (http://www.sdotson.com/freetut/adaptivity%20101.pdf)
Part 2 (http://www.sdotson.com/freetut/adaptivity%20102.pdf)
Part 3 (http://www.sdotson.com/freetut/adaptivity%20103.pdf)
Part 4 (http://www.sdotson.com/freetut/adaptivity%20104.pdf)