BASIC stamps

[[527]phil]

Can anyone tell me which pins on the bottom of this BASIC stamp i connect a pwm wire into in order to connect it to the servo controller underneath it

http://www.parallax.com/images/prod_gif/27290.gif

http://www.parallax.com/images/prod_gif/28023.gif

[Andy Brockway]

Phil,

To be safe you should check the parallax web site.....

Essentially all of the pins marked P# are available as inputs or outputs and so are eligible to be used for PWM outputs. I am not sure which servo controller you are using but typically they require a serial out line to the the controller. Again, any of the pins marked P# are available. You then use SEROUT to send the command to the servo controller. Check the documentation that came with your servo controller.

Check this (http://www.chiefdelphi.com/forums/showthread.php?t=27056&highlight=pwm) thread for more info.