[OCCRA]: drill motor sproket

[xzvrw2]

is there a way to get the sproket off of the drill motor?

[greencactus3]

?? the bolt is reeverse thread.. so you turn clockwise to loosen.... and then the sprocket itself should be regular thread. if you used locktite.. which i reccomend, it might be stiff. but how are you haveing trouble getting it off?

[Lisa Perez]

Stevie... Are you referring to the gear on the shaft coming directly from the motor itself?

[greencactus3]

as in inside the tranny?

[xzvrw2]

No, I am talking about the sprocket on the outside of the transmission. I think it is a nine tooth sprocket. I want to take that off to put this thing on there so I can put 3/8" shaft.

[Silent_Stryker]

this was answered
here (http://www.chiefdelphi.com/forums/showthread.php?t=39733) already

[xzvrw2]

OK thanks