PWM 2 pin jumper

[mechanicalbrain]

Ive seen PWM 2 pin jumpers on ifirobotics.com (more specifically on this page (http://www.ifirobotics.com/accessories.shtml)) and a number of BattleBots stores but I'm not familiar with their purpose. I also know that they are used a bunch in computers (I harvested 9 out of one of the older computers I had). Any insights would be welcomed. :)

[sciguy125]

They're used to short together two adjacent pins. Normally for different settings, as is their purpose on the Victors.

[Kyle Love]

I know in VEX they also determine if the robot runs automode or driver control.

[Mark McLeod]

A place you'll find one of these jumpers, other than on the Victors, is on the OI. It is used to select between the two possible dashboard readouts (RC or OI).

[Al Skierkiewicz]

It is the Brake/Coast jumper on the speed controller. This is the same jumper that can be found in computer hardware like motherboards, disk drives and expansion cards. It is also known as a zero ohm jumper.