Log in

View Full Version : Servos not getting right voltage

sheyna
17-01-2006, 17:16
ok my cmucam takes picture perfectly but my servos dont move. we tested the pulse width modulation on our oscilloscope and it is giving out the right pulses and the batter is giving out 7.5 but we test the pins where the servos connect and it is giving out only 1.5. what do you think the problem is?

~sheyna
railerobotics
17-01-2006, 17:55
Are your servos connected to the camera or the robot controller?
Alan Anderson
17-01-2006, 21:57
If the servos are plugged directly into the camera, make sure the "servo power" jumper is connected properly.