Servo input values

[bush]

Is the range of input to the servos 0-255?

[chrisinmd]

Is the range of input to the servos 0-255?

yes
they operate on the same PWM signal that the victors do
knowing this, you can use the servos in the kit to test your code w/out hooking up speed controllers and motors, just plug the servos in to the robot controller
make sure you plug in a backup battery, that's where they get their 7.2v from.
-Chris

[Jared Russell]

Is the range of input to the servos 0-255?

NO!!!

0-254, just like any other IFI pwm signal.

255 is reserved for a special "beginning of data packet" byte - you can get some wacky behavior if you use it. Stick to 0-254.

[steven114]

The new controllers automatically replace 255s with 254s to fix that exact problem. On the old PBASIC controllers, if you sent pairs of 255s you'd get all kinds of problems...

[chrisinmd]

NO!!!

0-254, just like any other IFI pwm signal.

255 is reserved for a special "beginning of data packet" byte - you can get some wacky behavior if you use it. Stick to 0-254.

thanks for correcting me, I need to be getting more sleep!
-Chris

[Al Skierkiewicz]

Check the data sheet for the individual servo to determine it's exact response, i.e. angle vs. PWM.