Log in

View Full Version : Sensor Help

itzrobz
05-02-2006, 13:46
Does anyone know how to set up a trans-beam receiver and trans-beam source?

Any help would be greatly appreciated.
Thanks :) :) :)
Jon236
05-02-2006, 14:07
Does anyone know how to set up a trans-beam receiver and trans-beam source?

Any help would be greatly appreciated.
Thanks :) :) :)

Look on the side of each module......there is a little wiring digram. The transmitter (the one with 2 wires) gets 12v supplied. The receiver needs 5v. Each signal (NO and NC) gets pulled up with a resistor to 5v. You will need some perf board to get it all connected. You can choose to use either ouput, or both....each to its own digio.